Certificates

More than 35 years of experience


OXITEC 5000+

Suitability Tested according to EN 15267

QAL1 Certified


OXITEC 5000+

MCERTS Performance Standards for Continuous Emission
Monitoring Systems, Version 3.5

DIN ISO 9001 Certificate

Quality management system, meets the requirements of
BS EN ISO 9001
(BSI British Standards Institution, United Kingdom)

SCC Certificate

"Safety Certificate Contractors"

SCCP for service, maintenance and on-site repair of gas analyzer systems, installation and commissioning of emission and operational measurements.

Certificate TÜV Suitability Test

Oxygen measurement OXITEC® 500E / SME5 TÜV suitability test for DIN EN 14181  and DIN EN ISO 14956.  The measuring device complies with the requirements of QAL 1. This certificate is only valid for current installations.

ATEX Certification

OXITEC®/COMTEC® electronic unit SME-5D

The marking for the electronic equipment is:
II 2 GD EEx d II C T6 or T5 IP 66 T 85 or T100°C

ATEX Certification

OXITEC®/COMTEC® electronic unit SME-5

The marking for the electronic equipment is:
II 2G Ex d IIC T6 Gb IP 66 T 85 or T100°C

ATEX Certification

OXITEC® 5000 Oxygen Measuring Probe Type KEX 5001

and KEX 5002.

The marking for the electronic equipment is:
II 2G Ex d IIC T3 Gb

ATEX Certification

COMTEC® 6000 O2/COe Measuring Probe Type KEX 6001 and KEX 6002. The marking for the device is:
II 2G Ex dIIC T3 Gb

ATEX Certification

COMTEC® 6000 O2/COe Measuring Probes KES 6001and KES 6002 in dust protection tube. The marking for the electronic equipment is:

II 2D EEx IP 6X T133°C/T141°C

CENELEC Certification

OXITEC® 5000 O2 Probe Ex version KES200Ex. The marking for the electronic equipment is

EEx d IIB T2

TÜV SÜD

UL / CSA Panel Shop Approval

ENOTEC conforms to UL / CSA standards listed below:

UL 508A

EAC

Eurasian Conformity Mark

Conformity to all technical regulations of the Eurasian Customs Union assessment procedures and replaces the Gost mark.

HART Interface Specification

Highway Addressable Remote Transducer (HART) is a standardized, widely used communication system for establishing industrial field buses. It allows digital communication between several OXITEC® 5000 or COMTEC® 6000 (field devices) on a common data bus. HART relies specifically on the also popular 4 / 20 mA standard (for transmission of analog sensor signals).

SIL

Safety Integrity Level (SIL) is defined as a relative level of risk-reduction provided by a safety function, or to specify a target level of risk reduction. In simple terms, SIL is a measurement of performance required for a Safety Instrumented Function (SIF).
This certificate is only valid for current installations.

SIL2

Safety Integrity Level (SIL) is defined as a relative level of risk-reduction provided by a safety function, or to specify a target level of risk reduction. In simple terms, SIL is a measurement of performance required for a Safety Instrumented Function (SIF).
This certificate is only valid for current installations.

(Certificate can be sent by post on request)